A garage door is usually the largest moving object in a house, and its springs hold enough tension to cause serious injury. Most problems give warning first. These checks are the ones a technician would run, minus anything that needs tools near the springs.
What Summit homes are up against
Summit is the Hill City, and a lot of its housing went up before 1940. On the Northside and around Prospect Hill, garages were often added or enlarged long after the house was built, so the door openings are narrow, the headroom is low and the opener sits close to the ceiling. In a tight garage, the first safety job is space: keep bikes, bins and ladders clear of the tracks and of the two photo-eyes near the floor, and test the auto-reverse monthly by closing the door onto a flat piece of wood.
The hills matter too. A driveway that slopes toward the garage brings water, grit and ice to the bottom of the door all winter. Check the bottom seal each fall and watch the door close from inside. If light shows under one corner, a cable has stretched or the slab has shifted, and the door needs adjusting by a technician. Wood and wood-overlay doors on Summit's older Colonials and Tudors also get heavier as their finish wears. A door that no longer stays put when lifted halfway by hand is out of balance and should not be run on the opener.
Every month
- Watch it run: the door should travel smoothly and evenly. A jerk, a pause or one side lagging behind the other is worth a closer look.
- Balance check: pull the red release cord with the door closed and lift it by hand to waist height. A balanced door stays put; one that drops or shoots up has a spring problem.
- Look at the cables on both sides at the bottom corners. Frayed strands or rust are a reason to call, not to keep using the door.
- Check the wall button is mounted high enough that small children can't reach it, and keep remotes out of their reach too.
- Photo-eye test: start closing the door and wave a broom handle through the beam near the floor. The door should stop and reverse.
Before winter
- Note where the manual release cord is and practise using it once while the door is closed.
- Put a battery in the opener's backup if it has one; winter storms are when power cuts strand cars.
- Clear leaves and grit from the bottom of the tracks so rollers don't bind when it gets cold.
- Clean the photo-eye lenses; condensation and grime are a common cause of doors that refuse to close.
During cold weather
- Expect springs to break more often in a cold snap. A loud bang from the garage on a frigid morning is usually a spring.
- Keep the area under the door clear of ice ridges so the door can seal and the reverse system isn't fooled.
- If the door is frozen to the ground, don't keep pressing the button. Free the seal gently with a plastic scraper or warm (not boiling) water, then try again.
Spring and summer
- Tighten loose bolts on hinges and brackets with a socket wrench, except anything attached to the springs or the bottom corner brackets.
- Wash the door and check painted wood or steel for peeling and rust spots before they spread.
- Check that weatherstripping along the sides hasn't dried out or cracked in the heat.
Stop using the door and call if
- A loud bang, then a door that won't lift: a spring has broken.
- A cable hanging loose or a door hanging crooked.
- A roller out of its track or a door stuck partway.
- The door fails the reverse test.
- Visible gaps or cracks in a spring.
Never
- Never adjust, loosen or remove springs, cables or the bottom brackets yourself; they hold the door's full weight under tension.
- Never walk or let children run under a moving door.
- Never keep using the opener on a door that's crooked or heavy; it will strip the gears or pull the door off its track.